Commander 4WD V8-4.7L (2008)
Rear Door Window Regulator: Service and Repair
Rear Door Window Regulator - Removal
REMOVAL
1. Remove the watershield See: Rear Door Panel/Service and Repair/Rear Door Watershield/Removal.
2. Temporarily install the window switch and position the glass fully up to gain access to the glass clamp screws.
3. Tape the glass securely into place.
4. Loosen the bolt in each of the window regulator glass clamps just far enough to release the door glass from the clamps. Do not completely remove.
5. Remove the bolts (1 and 4) that secure the window regulator rail to the inside of the door.
6. Disconnect the electrical connector (3).
7. Lower the regulator and remove the regulator from the door.
