Commander 4WD V8-4.7L (2008)
Trunk / Liftgate Motor: Service and Repair
Power Liftgate Drive Unit - Installation
INSTALLATION
1. Position the power liftgate drive unit assembly (1) into the vehicle.
2. Position the drive unit assembly lower mounting bracket onto the cargo floor stud (3).
3. Hook the drive unit assembly upper mounting bracket onto the D-pillar (2).
4. Install the drive unit retaining nut (4). Tighten the nut to 28.5 Nm (21 ft. lbs.).
5. Install the drive unit retaining bolts (5). Tighten the bolts to 28.5 Nm (21 ft. lbs.).
6. Connect the wire harness connector to the drive unit assembly (1).
7. Install the left quarter trim panel, . See: Interior Moulding / Trim/Trim Panel/Service and Repair/Quarter Panel Trim/Quarter Trim Panel -
Installation
8. Install the left rear D-pillar trim panel, See: Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/D-Pillar Trim/Installation.
9. Install the link rod assembly, See: Link Rod/Installation for the appropriate procedure.
10. Connect the battery negative cable.
11. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
12. Perform the power liftgate learn cycle, See: Service and Repair/Procedures/Power Liftgate Learn Cycle.
13. Verify power liftgate system operation.
