Commander 4WD V8-4.7L (2008)
1. Install the drive unit end of the link rod (1) onto the mounting sphere by gently pushing straight on.
2. Install the liftgate end of the link rod (1) onto the liftgate (3) pivot bracket (2) by gently pushing straight on.
3. Push the plastic retainer (1) down to lock the link rod mounting sphere (2) into position for both ends of the link rod.
4. Install the D-pillar trim on the vehicle. See: Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/D-Pillar Trim/Installation for the
procedure.
5. Perform the power liftgate learn cycle, See: Service and Repair/Procedures/Power Liftgate Learn Cycle.
