Commander 4WD V8-4.7L (2008)
Passenger Assist Handle: Service and Repair
Handle-Roof Grab
Removal
REMOVAL
1. Pull the grab handle downward, remove the two screws that secure the grab handle to the roof panel, and remove the grab handle from the
headliner.
2. If equipped, disconnect the reading lamp wire harness connector.
Installation
INSTALLATION
1. If equipped, connect the reading lamp wire harness connector.
2. Position the grab handle on the headliner and install the two screws that secure the grab handle to the roof panel. Tighten the screws to 2 Nm (20
in. lbs.).
