Commander 4WD V8-4.7L (2008)
2. Position the door trim panel near the rear door and connect the door wire harness connector (3) to the power door switch assembly (1).
3. Connect the interior door handle actuator rod (3) to the interior door handle and engage the retainer.
4. Lift the rear trim panel (2) over the inside of the door far enough to engage the interior door latch lock link and knob (1) into the hole at the upper
rear corner of the trim panel.
5. Position the trim panel to the inside of the door and fully engage the new plastic door trim panel retention clips (3) to the door.
6. Install the two screws that secure door trim panel to the door.
7. Reconnect the negative battery cable.
