Commander 4WD V8-4.7L (2008)
Air Door Actuator / Motor: Service and Repair
Blend Door Actuator - Installation
Front Controls
INSTALLATION
NOTE: The single zone heater-A/C system is equipped with a single blend door actuator. The dual zone system has two blend door actuators,
one for the driver side blend-air door and one for the passenger side blend-air door.
SINGLE ZONE/DUAL ZONE LH SIDE
1. Position the blend door actuator (1) into the vehicle.
2. Install the blend door actuator onto the left side of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align the
splines on the actuator output shaft (3) with those on the blend door cam (4).
3. Install the screws (1) that secure the blend door actuator (2) to the left side of the air distribution housing (3). Tighten the screws to 2 Nm (17 in.
lbs.).
4. Connect the HVAC wire harness connector (4) to the blend door actuator.
5. Install the instrument panel silencer onto the driver side of the instrument panel.
6. Reconnect the negative battery cable.
DUAL ZONE RH SIDE
