Commander 4WD V8-4.7L (2008)
11. Remove the blend door actuator from the vehicle.
Rear Controls
REMOVAL
1. Remove rear HVAC housing (1) and place it on a workbench .
2. Disconnect the rear HVAC wire harness connector (2) from the rear blend door actuator (3).
3. Remove the two screws (4) that secure the rear blend door actuator to the back of the rear HVAC housing and remove the actuator.
Front Controls
INSTALLATION
NOTE: The single zone heater-A/C system is equipped with a single blend door actuator. The dual zone system has two blend door actuators,
one for the driver side blend-air door and one for the passenger side blend-air door.
SINGLE ZONE/DUAL ZONE LH SIDE
1. Position the blend door actuator (1) into the vehicle.
2. Install the blend door actuator onto the left side of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align the
splines on the actuator output shaft (3) with those on the blend door cam (4).
