Commander 4WD V8-4.7L (2008)
11. Install the glove box into the instrument panel See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Instrument
Panel Glove Box - Installation.
13. Reconnect the negative battery cable.
Rear Controls
INSTALLATION
1. Position the rear blend door actuator (1) onto the back of the rear HVAC housing (2). If necessary, rotate the actuator slightly to align the splines
on the actuator output shaft (4) with those in the rear blend door pivot shaft (3).
2. Install the two screws (4) that secure the rear blend door actuator (3) to the rear HVAC housing (1). Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the rear HVAC wire harness connector (2) to the rear blend door actuator.
4. Install the rear HVAC housing .
5. Initiate the Actuator Calibration function using a scan tool. Refer to HVAC System Test. See: Testing and Inspection/Component Tests and
General Diagnostics/HVAC System Test
Front Controls
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: The heater-A/C system is equipped with two mode door actuators. One for the air doors for the outlets in the instrument panel and one
for the air door for the 2nd row/console outlets.
PANEL/DEFROST/DEMIST/FLOOR
