Commander 4WD V8-4.7L (2008)
1. Disconnect and isolate the negative battery cable.
2. On LHD models, remove the instrument panel silencer from the driver side of the instrument panel.
3. Remove the three screws (1) that secure the mode door actuator (2) to the left side of the HVAC air distribution housing (3).
4. Remove the mode door actuator from the air distribution housing and disconnect the HVAC wire harness connector (4) from the actuator.
5. Remove the mode door actuator from the vehicle.
2nd ROW/CONSOLE
6. Disconnect and isolate the negative battery cable.
7. Remove the instrument panel from the vehicle See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel - Removal.
8. Remove the two screws (1) that secure the mode door actuator (2) to the rear of the HVAC air distribution housing (3).
9.
Remove the mode door actuator from the air distribution housing and disconnect the HVAC wire harness connector (4) from the actuator.
10. Remove the mode door actuator from the vehicle.
Rear Controls
REMOVAL