Commander 4WD V8-4.7L (2008)
Receiver Dryer: Service and Repair
Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution. Failure to follow the warnings and cautions could result in possible personal
injury or death.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Service and Repair/Refrigerant System Recovery.
3. Remove the grille See: Body and Frame/Grille/Service and Repair/Grille - Removal.
4. Remove the air cleaner housing and air inlet tube .See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing
5. Remove the nut (1) that secures the A/C liquid line (2) to the A/C receiver/drier (3).
6. Remove the A/C liquid line from the A/C receiver/drier and remove and discard the dual-plane seal.
7. Remove the screw (4) that secures the A/C receiver/drier to the radiator and fan shroud (5).
8. Remove the nut (6) that secures the A/C receiver/drier to the A/C condenser (7).
9. Disconnect the A/C receiver/drier from the A/C condenser and remove and discard the dual-plane seal.
10. Install plugs in, or tape over the opened receiver/drier fitting and port and the condenser port.
