Commander 4WD V8-4.7L (2008)
Parking Light Bulb: Service and Repair
Installation
BULB - PARK/TURN SIGNAL
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
1. Align the base of the bulb with the park/turn signal bulb socket (5).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the bottom of the front lamp unit housing.
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Lower and snap the cover back over the access hole at the front of the wheel house splash shield.
7. Lower the vehicle.
8. Reconnect the battery negative cable.
