Commander 4WD V8-4.7L (2008)
Horn Switch: Service and Repair
Installation
INSTALLATION
WARNING: On vehicles equipped with airbags, refer to restraints before attempting any steering wheel, steering column, or instrument panel
component diagnosis or service. Failure to take the proper precautions could result in accidental airbag deployment and possible personal
injury.
1. Install the horn switch (2) and tray as a unit into the pouch on the retaining strap of the driver side airbag (5).
NOTE: Be certain that the tray is facing the airbag module, that the horn switch is facing the trim cover, that the horn switch feed wire is
on the left, and that the horn switch ground wire is on the right.
2. Install the trim cover onto the driver side airbag. See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Airbag - Installation
for the procedure.
3. Connect the battery negative cable.
