Commander 4WD V8-4.7L (2008)
Power Trunk / Liftgate Control Module: Service and Repair
Installation
INSTALLATION
1. Position the power liftgate control module (1) into the vehicle.
2. Install the power liftgate control module (1) onto the retaining tabs of the left rear wheel well (2).
3. Connect the wire harness connectors (3) to the power liftgate control module (1).
4. Install the left quarter trim panel, . See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Quarter Panel Trim/Quarter
Trim Panel - Installation
5. Connect the battery negative cable.
6. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
7. Perform the power liftgate learn cycle, See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Procedures/Power
Liftgate Learn Cycle.
8. Verify power liftgate system operation.