Commander 4WD V8-4.7L (2008)
9. Insert the upper tabs of the turning loop trim cover into the slots of the height adjuster on the upper B-pillar, then lower the bottom of the cover
and use hand pressure to press firmly and evenly on the cover until it snaps into place.
10. Position the seat belt lower anchor to the mounting hole on the outboard side of the front seat cushion frame. Be certain that the seat belt webbing
between the turning loop and the lower anchor is not twisted.
11. Install and tighten the screw (2) that secures the lower anchor to the seat. Tighten the screw to 39 Nm (29 ft. lbs.).
12. Reinstall the lower anchor cover (1) onto the front seat cushion outboard side shield.
Second Row Center
SECOND ROW CENTER
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Position the second row center seat belt and retractor unit through the opening in the front upper right corner of the seat back frame (2). Be certain
to engage the tab on the retractor into the slot (1) in the back of the seat back frame.
2. Install and tighten the screw (3) into the back of the center seat back frame that secures the retractor. Tighten the screw to 50 Nm (37 ft. lbs.).
