Commander 4WD V8-4.7L (2008)
Ultrasonic Sensor: Service and Repair
Removal
Receiver
RECEIVER
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console from the headliner. See: Accessories and Optional Equipment/Driver/Vehicle Information Display/Service and
Repair/Removal and Replacement/Overhead Console - Removal.
3. Locate the intrusion sensor receiver (3) in the mounting bracket (4) on the left rear corner of the overhead console housing (5).
4. Disconnect the take out of the overhead wire harness from the connector receptacle (2) on the forward end of the receiver housing.
5. Release the three latch features (1) of the mounting bracket and disengage the receiver from the bracket.
Transmitter
TRANSMITTER
1. Disconnect and isolate the battery negative cable.
2. Pull the bezel (1) straight out from the headliner (3) to unsnap it from the transducer housing (2) of the intrusion sensor transmitter. Be certain to
take the appropriate precautions not to soil or damage the headliner.
3. Remove the trim from the upper liftgate opening. .See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim
Panel/Service and Repair/Liftgate Trim Panel - Removal
4. Remove the trim from the left upper D-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/D-Pillar
Trim/Removal.
