Commander 4WD V8-4.7L (2008)
Power Trunk / Liftgate Hazard Sensor: Service and Repair
Removal
REMOVAL
1. Open the liftgate.
2. Disconnect and isolate the battery negative cable.
3. Remove the liftgate lower trim panel, See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim Panel/Service
and Repair/Liftgate Trim Panel - Removal.
4. Disconnect the pinch sensor wire harness connector (4).
5. Remove the screws (1) holding the pinch sensor (5) to liftgate (2).
6. Remove the pinch sensor wire harness grommet (3) out of the liftgate (2) and remove the sensor from the vehicle.
