Commander 4WD V8-4.7L (2008)
6. Install the outer tie rod ends (2) to the knuckle (5) and tighten the tie rod end nut (1) to 95 Nm (70 ft. lbs.).
7. Install the pressure and return hoses (2&3) to the steering gear (1) and tighten to 28 Nm (21 ft. lbs.).
8. Install the oil filter drip tray (1).
9. Install the column coupler shaft into the lower coupling (1) and install a new bolt (2), Tighten to 49 Nm (36 ft. lbs.).
10. Install the front axle housing unit See: Transmission and Drivetrain/Differential Assembly/Service and Repair/Removal and Replacement/Front
Axle - C200FE/Installation. 4x4 ONLY
11. Install the wheel and tire assembly.
12. Remove the support and lower the vehicle.
13. Remove the steering wheel lock.
14. Fill the power steering pump See: Power Steering/Power Steering Bleeding/Service and Repair.
15. Set the toe. See: Alignment/Service and Repair.