Commander 4WD V8-4.7L (2008)
Front Cross-Member: Service and Repair
Installation
INSTALLATION
1. Install the sway bar onto the engine cradle as necessary. See: Stabilizer Bar/Service and Repair/Front Stabilizer Bar - Installation
2. Install the lower control arms as necessary. See: Control Arm/Service and Repair/Front Lower Control Arm - Installation
3. Raise the engine cradle into position guiding the engine mount bolts into the engine cradle slots.
4. Install the four engine cradle bolts (1 & 2).
5. Align the engine cradle to the marks made during removal and tighten the front bolts (1) to 203 Nm (150 ft. lbs.).
6. Tighten the rear bolts (2) to 122 Nm (90 ft. lbs.).
7. Install the steering gear as necessary. See: Steering/Steering Gear/Service and Repair/Steering Gear - Installation
8. Lower the engine fully onto the engine mounts.
