Commander 4WD V8-4.7L (2008)
9. Install the wiring harness connectors (3) to the shifter assembly (1).
10. Verify that the shift lever is in the PARK position.
11. Tighten the adjustment screw to 30 Nm (265 in.lbs.).
12. Verify that the key in the LOCK position and the shifter is in PARK.
13. Push downward on the park lock cable adjustment tab to lock the adjustment.
14. Verify correct shifter, park lock, and BTSI operation.
15. If necessary, install the shield, covering the gearshift and park lock cables, to the shifter assembly and install the bolts to hold the shield to the
shifter assembly.
16. Install any console parts removed for access to shift lever assembly and shift cables. See: Body and Frame/Interior Moulding /
Trim/Console/Service and Repair/Floor Console - Installation