Commander 4WD V8-4.7L (2008)
10. Apply bead of Mopar(R) Gasket Maker, or equivalent, to mating surface of front case. Keep sealer bead width to maximum of 3 mm (0.125 inch).
Do not use excessive amount of sealer as excess will be displaced into case interior and potentially clog the oil pump screen.
11. Verify that the tab on the thrust bearing support plate is aligned with the housing alignment dowel furthest from the front output shaft.
12. Install the rear housing (1) into the front housing (2).
13. Install the bolts (2) to hold the rear housing (1) to the front housing (3). Tighten the bolts at the dowel locations first, then the remainder of the
bolts in a criss-cross pattern. Tighten the bolts to 27 Nm (20 ft.lbs.).
NOTE: Pull up on the main shaft when installing the retaining ring to ensure that the ring is fully engaged into the groove.
14. Install the rear main shaft (1) retaining ring (2).
