Commander 4WD V8-4.7L Flex Fuel (2009)
Garage Door Opener Transmitter: Programming and Relearning
Programming Transmitter Codes
PROGRAMMING TRANSMITTER CODES
Programming Common Transmitter Codes
WARNING: Vehicle exhaust contains carbon monoxide, a dangerous gas. Do not run the vehicle's exhaust while training the transceiver.
Failure to follow these instructions may result in possible serious or fatal injury.
WARNING: Your motorized door or gate may open and close while you are training the Universal Transceiver if the vehicle is in range of the
motorized device. Do not train the transceiver if people or pets are in the path of the door or gate. A moving door or gate can
cause serious injury or death to people and pets or damage to objects.
NOTE: When programming a garage door opener, it is advised to park outside the garage. It is also recommended that a new battery be
placed in the hand-held transmitter of the device being programmed to HomeLink(R) for quicker training and accurate transmission
of the radio-frequency signal.
The Electronic Vehicle Information Center (EVIC) features a driver-interactive display which includes HomeLink(R) system messages. The EVIC is
located in the upper part of the cluster between the speedometer and tachometer.
1. Press and hold the two outer HomeLink(R) buttons (5), and release only when the EVIC display shows "Channels Cleared" (after 20 seconds).
Do not hold the buttons for longer than 30 seconds and do not repeat step one to program a second and/or third hand-held transmitter to the
remaining two HomeLink(R) buttons.
2. Position the end of your hand-held transmitter 1-3 inches (3-8 cm) away from the HomeLink(R) buttons.
3. Simultaneously press and hold both the HomeLink(R) button that you want to train and the hand-held transmitter buttons. Do not release the
buttons until step 4 has been completed.
NOTE: Some gate operators and garage door openers may require you to replace this Programming Step 3 with procedures noted in the
"Gate Operator/Canadian Programming" section.
4. The EVIC display will show "Channel X Training" (where X is Channel 1, 2, or 3). Release both buttons after the EVIC display shows
"Channel X Trained". NOTE: If the EVIC display shows "Did Not Train" repeat steps 2-4.
5. Press and hold the just trained HomeLink(R) button and observe the EVIC display. If the EVIC display shows "Channel X Transmit" (where X
is Channel 1, 2, or 3), programming is complete and your device should activate when the HomeLink(R) button is pressed and released. NOTE:
To program the remaining two HomeLink(R) buttons, begin with "Programming" step two. Do not repeat step one.
NOTE: If your hand-held transmitter appears to program the universal transceiver, but your garage door does not operate using the
transmitter and your garage door opener was manufactured after 1995, your garage door opener may have a multiple security code system
(rolling code system). Please proceed to steps 6-8 to complete the programming of a rolling code equipped device (most common garage door
openers require this step.
6. At the garage door opener receiver (motor-head unit) in the garage, locate the "learn" or "smart" button. This can usually be found where the
hanging antenna wire is attached to the motor-head unit.
7. Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer.)NOTE: There are 30
