Commander 4WD V8-4.7L Flex Fuel (2009)
Power Trunk / Liftgate Hazard Sensor: Service and Repair
Pinch Sensor - Removal
REMOVAL
1. Open the liftgate.
2. Disconnect and isolate the battery negative cable.
3. Remove the liftgate lower trim panel, See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim Panel/Service and
Repair/Liftgate Trim Panel - Removal.
4. Disconnect the pinch sensor wire harness connector (4).
5. Remove the screws (1) holding the pinch sensor (5) to liftgate (2).
6. Remove the pinch sensor wire harness grommet (3) out of the liftgate (2) and remove the sensor from the vehicle.
