Commander 4WD V8-4.7L Flex Fuel (2009)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System Module - Installation
INSTALLATION
CAUTION: When removing ABM from HCU, be sure to completely separate the two components (approximately 38 mm (1.5 in.) before
removing ABM. Otherwise, damage to the pressure sensor or Pump Motor connection may result requiring HCU replacement. Do
not to touch the sensor terminals on the HCU side or the contact pads on the ABM side as this may result in contamination and
issues in the future.
NOTE: If the ABM is being replaced with a new ABM is must be reprogrammed with the use of a scan tool.
1. Install new seals between the ABM and HCU.
2. Install the ABM (1) to the HCU (2).
3. Install the 3 ABM (1) mounting bolts to the HCU (2) if removed tighten mounting bolts to 12 Nm (9 ft. lbs.).
