Commander 4WD V8-4.7L Flex Fuel (2009)
Air Door Actuator / Motor: Service and Repair
Mode Door Actuator - Installation
Front
INSTALLATION
PANEL/DEFROST/DEMIST/FLOOR
1. Position the mode door actuator (1) into the vehicle.
2. Install the mode door actuator onto the left side of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align the
splines on the actuator output shaft (3) with those on the mode door cam (4).
3. Install the screws (1) that secure the mode door actuator (2) to the left side of the air distribution housing (3). Tighten the screws to 2 Nm (17 in.
lbs.).
4. Connect the HVAC wire harness connector (4) to the mode door actuator.
5. On LHD models, install the instrument panel silencer onto the driver side of the instrument panel.
6. On RHD models, install the glove box into the instrument panel See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and
Repair/Instrument Panel Glove Box - Installation.
7. Reconnect the negative battery cable.
8. Initiate the Actuator Calibration function using a scan tool . See: Testing and Inspection/Component Tests and General Diagnostics/HVAC
System Test
2nd ROW/CONSOLE
