Commander 4WD V8-4.7L Flex Fuel (2009)
Hose/Line HVAC: Removal and Replacement
A/C Discharge Line - Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution . Failure to follow these instructions may result in serious or fatal injury.
NOTE: LHD model shown in illustrations. RHD model similar.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Service and Repair/Refrigerant System Recovery.
3. Remove the grille See: Body and Frame/Grille/Service and Repair/Grille - Removal.
4. Remove the air cleaner housing, air intake tube and the resonator See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance
Checks/Air Cleaner Housing/Service and Repair/Air Cleaner Body - Removal.
5. Disconnect the wire harness connector (8) from the A/C pressure transducer (7) and remove the transducer from the A/C discharge line (5), if
required.
6. Remove the nut (6) that secures the A/C discharge line to the A/C condenser (4).
7. Disconnect the A/C discharge line from the A/C condenser and the retaining bracket (9) and remove and discard the dual plane seal.
8. Remove the nut (2) that secures the A/C discharge line (1) to the A/C compressor (4).
9. Disconnect the A/C discharge line from the A/C compressor and remove and discard the dual plane seal.
10. Install plugs in, or tape over the opened refrigerant line fittings and the compressor and condenser ports.
11. Remove the A/C discharge line from the engine compartment.
A/C Discharge Line - Installation
