Commander 4WD V8-4.7L Flex Fuel (2009)
Glove Box Lamp: Service and Repair
Glove Box Lamp/Switch - Removal
LAMP/SWITCH
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Open the glove box.
3. Reach through and above the glove box opening to access and depress the latch feature on either side of the glove box lamp and switch unit (1).
4. While holding the retaining latch depressed, push the glove box lamp and switch unit out through the mounting hole in the face of the instrument
panel.
5. Disconnect the wire harness connector from the glove box lamp and switch.
6. Remove the lamp and switch unit from the instrument panel.