Commander 4WD V8-4.7L Flex Fuel (2009)
5. Insert the socket and bulb into the housing until the socket is firmly seated.
6. Rotate the socket clockwise about 30 degrees to lock it into place.
7. Reinstall the repeater lamp into the fender mounting hole. . See: Service and Repair/Side Repeater Lamp - Installation
8. Reconnect the battery negative cable.
Tail Stop Turn Lamp Bulb - Removal
BULB
NOTE: The rear lamp unit (1) contains four bulbs. For domestic market vehicles they are: backup (2), park/stop (3), park/turn signal (4) and
rear side marker (5). For export market vehicles they are: turn signal (2), park/stop (3), park (4) and backup (5). The service
procedures for each bulb are the same, only the bulb sizes and types may differ.
1. Disconnect and isolate the battery negative cable.
2. Remove the rear lamp unit (1) from the end of the quarter panel. See: Brake Lamp/Service and Repair/Tail Stop Turn Lamp - Removal.
3. Firmly grasp the appropriate bulb socket (2, 3, 4 or 5) on the back of the rear lamp unit housing and rotate it counterclockwise about 30 degrees to
unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb straight out of the socket.
Tail Stop Turn Lamp Bulb - Installation
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The rear lamp unit (1) contains four bulbs. For domestic market vehicles they are: backup (2), park/stop (3), park/turn signal (4) and
