Commander 4WD V8-4.7L Flex Fuel (2009)
Fuse Block: Service and Repair
Junction Block - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in accidental airbag deployment and possible personal injury.
1. Disconnect and isolate the battery negative cable.
2. Remove the steering column opening cover (2). This is accomplished by pulling outward on the upper edge of the cover to disengage the retaining
clips and removing the screw at the bottom of the cover.
3. Disconnect the two bottom side Junction Block (JB) connectors.
