Commander 4WD V8-4.7L Flex Fuel (2009)
6. Remove the nut (2) that secures the A/C suction line (3) to the A/C compressor (4).
7. Disconnect the A/C suction line from the A/C compressor and remove and discard the dual plane seal.
8. Install plugs in, or tape over the opened suction line fittings and the compressor and expansion valve ports.
9. Remove the A/C suction line from the engine compartment.
Rear
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Heating and Air
Conditioning/Service Precautions/Warning and See: Heating and Air Conditioning/Service Precautions/Caution . Failure to follow these
instructions may result in serious or fatal injury.
NOTE: 4.7L engine shown. Other engines similar.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Recovery.
3. Raise and support the vehicle.
4. Remove the nut (5) that secures the tapping block of the suction line extension tube (4) to the underbody suction line (6).
5. Disconnect the suction line extension tube from the underbody suction line and remove and discard the O-ring seal.
6. Lower the vehicle.
7. Disconnect the A/C suction line (2) from the front A/C expansion valve (1) and the A/C compressor (3) and remove the suction line from the
engine compartment See: A/C Suction Line - Removal
8. Install plugs in, or tape over the opened refrigerant line fittings and expansion valve and compressor ports.
Front
INSTALLATION
