Commander 4WD V8-4.7L Flex Fuel (2009)
3. Position the retractor retainer bracket (2) over the top of the retractor pocket (4) on the front upper outboard corner of the seat back frame (3).
4. Install and tighten the through bolt (1) that secures the retainer bracket to the top of the retractor pocket on the seat back frame. Tighten the bolt to
43 Nm (32 ft. lbs.).
5. Reinstall the trim onto the top and the back of the third row seat back frame.
6. Slide the seat belt webbing (2) through the slot (3) in the seat belt escutcheon (1) and position the escutcheon to the top of the third row seat back
(5).
7. Install and tighten the two screws (4) that secure the escutcheon to the top of the seat back. Tighten the screws to 3 Nm (28 in. lbs.).
8. Position the seat belt lower anchor (4) to the outboard rear corner of the third row seat support bracket (1). Be certain that the belt webbing is not
twisted between the top of the seat back and the lower anchor.
