Commander 4WD V8-4.7L Flex Fuel (2009)
Ball Joint: Service and Repair
Front Suspension Upper Ball Joint - Removal
REMOVAL
1. Raise vehicle and support the axle.
2. Remove the tire and wheel.
3. Remove the upper ball joint retaining nut.
4. Separate the upper ball joint (2) from the knuckle (3) using special tool 8677 (1).
5. Move the knuckle (3) out of the way to allow ball joint removal tool access.
NOTE: When installing a new ball joint, Do not remove the rubber grease boot on the new ball joint during installation.
6. Remove the rubber grease boot from the ball joint in the control armThis will allow better fit of the ball joint tool when removing.
