Commander 4WD V8-4.7L Flex Fuel (2009)
manual shift lever to the full rearward position and turn the propeller shaft until the PARK system is engaged.
8. Route the gearshift cable (3) through the mounting bracket (4 ).
9. Engage the gearshift cable (3) eyelet onto the transmission manual shift lever (2).
10. Lower vehicle.
11. Verify that the shifter is in the PARK position.
12. Tighten the adjustment nut (2) to 30 Nm (265 in.lbs.).
13. Verify correct shifter operation.
14. If necessary, install the shield, covering the gearshift and park lock cables, to the shifter assembly and install the bolts to hold the shield to the
shifter assembly.
15. Install the floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Installation , lower
instrument panel components See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Installation and dash panel insulation pad as necessary.
