Commander 4WD V8-4.7L Flex Fuel (2009)
3. Remove propeller shaft (1) from axle pinion flange (2).
4. Remove propeller shaft (1) from vehicle transfer case flange (2) or transmission flange (3).
5. Remove propeller shaft from vehicle.
CAUTION: Failure to follow these instructions may result in a driveline vibration.
Front
INSTALLATION
NOTE: Clean all propeller shaft bolts and apply Mopar Lock & Seal Adhesive or Loctite(R) 242 to the threads before installation.
1. Install shaft with reference marks aligned on companion flanges.
2. Install propeller shaft (1) flange (2) bolts and tighten to 108 Nm (80 ft. lbs.).
