Commander 4WD V8-4.7L Flex Fuel (2009)
Axle Shaft: Service and Repair
Front Axle - C200FE
Removal
REMOVAL
1. Remove half shaft from vehicle.
2. Clean axle seal area.
3. Remove snap ring and O-ring from the axle shaft.
4. Remove axle (1) with Remove 8420A (2, 3, 4) and slide hammer.
Installation
INSTALLATION
1. Lubricate bearing bore and seal lip with gear lubricant.
2. Install axle shaft and engage shaft into side gear. Push firmly on axle shaft to engage snap-ring.
3. Check the differential fluid level and add fluid if necessary.
4. Install half shaft.
5. Install skid plate, if necessary.
