Commander 4WD V8-4.7L Flex Fuel (2009)
Rear Door Window Regulator: Service and Repair
Rear Door Window Regulator - Installation
INSTALLATION
1. Load the window regulator into the rear door through the large access hole in the door and connect the wire harness connector (3) to the regulator
motor.
2. Engage the glass into regulator clamps.
3. Install the bolts (1 and 2) that secure the regulator rails to the door. Tighten the bolts to 8.5 Nm (75 in. lbs.).
4. Carefully remove the tape securing the door glass in its full up position.
5. Temporarily install the window switch and raise the glass into the full up position.
6. Tighten the bolts in each of the window regulator glass clamps to 12 Nm (105 in. lbs.).
7. Install the watershield and the trim panel onto the inside of the front door. See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front
Door Panel/Service and Repair/Front Door WaterShield - Installation
8. Install the watershield (1). See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair/Watershield -
Installation
9. Perform the Clear/Relearn procedure. See: Testing and Inspection/Programming and Relearning
