Commander 4WD V8-4.7L VIN N (2006)
3. Use piston ring compressor (3) and Guide Pins Special Tool 8507 (4) to install the rod and piston assemblies. The oil slinger slots in the rods must
face front of the engine. The "F"s near the piston wrist pin bore should point to the front of the engine.
4. Install the lower bearing insert in the bearing cap Center bearing insert (2) in connecting rod (1).. The lower insert must be dry Place strip of
Plastigage across full width of the lower insert at the center of bearing cap. Plastigage must not crumble in use. If brittle, obtain fresh stock.
5. Install bearing cap and connecting rod on the journal and tighten bolts to 27 Nm (20 ft. lbs.) plus a 90° turn. DO NOT rotate crankshaft.
Plastigage will smear, resulting in inaccurate indication.