Commander 4WD V8-4.7L VIN N (2006)
Front Crankshaft Seal: Service and Repair
SEAL - CRANKSHAFT OIL - FRONT
REMOVAL
1. Disconnect negative cable from battery.
2. Remove accessory drive belt.
3. Remove A/C compressor mounting fasteners and set aside.
4. Drain cooling system.
5. Remove upper radiator hose.
6. Disconnect electrical connector for fan mounted inside radiator shroud.
7. Remove radiator shroud attaching fasteners.
NOTE: Transmission cooler line snaps into shroud lower right hand corner.
8. Remove radiator cooling fan and shroud.
9. Remove crankshaft damper bolt.
10. Remove damper using Special Tools 8513 Insert and 1026 Three Jaw Puller (2).
11. Using Special Tool 8511 (1), remove crankshaft front seal.
INSTALLATION