Commander 4WD V8-4.7L VIN N (2006)
12. Disconnect the rear heater hoses (6) from the rear heater core tubes (5) which extends through the rear floor panel.
13. Remove the rear body cradle.
14. Remove the muffler and tail pipe as an assembly.
15. Remove the heat shields as required from the vehicle underbody.
16. Remove the two screws (1) that secure the underbody line assembly (2) to the front of the vehicle underbody (3).
17. Disengage the five mounting brackets that secure the underbody line assembly to the vehicle underbody.
18. Route the underbody line assembly over the rear axle and remove the line assembly from the vehicle.
INSTALLATION
1. Route the underbody line assembly (2) over the rear axle and position the line assembly to the vehicle underbody (3).
2. Engage the five mounting brackets that secure the underbody line assembly to the vehicle underbody.
3. Install the two screws (1) that secure the underbody line assembly to the front of the underbody. Tighten the screws securely.
4. Install the heat shields as required to the vehicle underbody.
5. Install the muffler and tail pipe as an assembly.
6. Install the rear body cradle.
