Commander 4WD V8-4.7L VIN N (2006)
Depending on the situation, there are two methods for initializing the PCM/ECM. Either Automatic Replacement or Service Replacement must be
performed. Automatic Replacement uploads the data from the old controller and downloads data to the new controller when the part numbers are
identical between the replacement and replaced controller. Service Replacement is used when part numbers are not identical or when the part number
is not recognized by the DRBIII(R).
Automatic Replacement
1.
**Using the DRBIII(R) select: "1. DRBIII(R) Standalone"
2.
"1.1998 - 2007 Diagnostics"
3.
Make the appropriate selection: "5. 2004 - 2006 Crossfire" or "6. 2002 - 2006 Sprinter"
4.
"1. System Select"
5.
"1. Engine"
6.
"9. Miscellaneous Functions"
NOTE:
For Sprinter only, injector classification must be recorded. Under Miscellaneous Functions, select "5. Injector Classification" then "2. Injector
Modification" on the DRBIII(R) and record the information for all 5 cylinders.
7.
"1. Module Auto Replacement"
8.
Follow the DRBIII(R) "On Screen" prompts until "Module Replacement Successful" message is displayed.
Module Service Replacement
1.
**Using the DRBIII(R) select: "1. DRBIII(R) Standalone"
2.
"1.1998 - 2007 Diagnostics"
3.
Make the appropriate selection: "5. 2004 - 2006 Crossfire" or "6. 2002 - 2006 Sprinter"
4.
"1. System Select"
5.
"1. Engine"
6.
"9. Miscellaneous Functions"
7.
"7. Read PCM Coding for Crossfire" OR "6 Read ECM Coding for Sprinter" and record all data.
NOTE:
Record all information shown on the PCM/ECM screen for future use.
Additionally, for Sprinter only, injector classification must be recorded.
Under Miscellaneous Functions, select "5. Injector Classification" then "2.
Injector Modification" on the DRBIII(R) and record the information for all 5 cylinders.
8.
Install new controller using the procedures found in TechCONNECT.
9.
Using the DRBIII(R), repeat above steps 1 through 6 and select "2. Module Service Replacement".
10.
Follow the DRBIII(R) "On Screen" prompts until "Module Replacement Successful" message is displayed.
11.
Was the message "Module Replacement Successful" received?
a.
Yes >> No Further Action is Required, Module has been successfully replaced.
b.
No >> proceed to the next Step # 12.
12.
Open TechAUTHORITY. TechAUTHORITY is available on the internet.
