Commander 4WD V8-4.7L VIN N (2006)
Accelerator Pedal: Service and Repair
Without APPS (Accelerator Pedal Position Sensor)
REMOVAL
The following procedure applies only to vehicles without the Adjustable Pedal Package (code XAP). It also applies to vehicles not equipped with an
accelerator pedal position sensor.
The accelerator pedal is serviced as a complete assembly including the bracket.
1. From inside the vehicle, hold up accelerator pedal. Remove plastic cable retainer (clip) (2) and throttle cable core wire from upper end of
accelerator pedal arm. Plastic cable retainer (clip) (2) snaps into top of pedal arm.
2. Remove two accelerator pedal mounting bracket nuts (3). Remove accelerator pedal assembly (2).
INSTALLATION
