Commander 4WD V8-4.7L VIN N (2006)
Accelerator Pedal: Service and Repair
With APPS (Accelerator Pedal Position Sensor)
REMOVAL
The following procedure applies only to vehicles without the Adjustable Pedal Package (code XAP). It also applies to vehicles equipped with an
accelerator pedal position sensor (6).
The accelerator pedal is serviced as a complete assembly including the bracket.
1. Disconnect electrical connector (3) at APPS (6).
2. Remove two accelerator pedal mounting bracket nuts (4). Remove accelerator pedal assembly.
3. Remove three sensor-to-pedal nuts (5). Remove APPS from accelerator pedal assembly.
INSTALLATION
The following procedure applies only to vehicles without the Adjustable Pedal Package (code XAP). It also applies to vehicles equipped with an
accelerator pedal position sensor.
The accelerator pedal is serviced as a complete assembly including the bracket.
1. Install APPS to pedal assembly and install three nuts (5).
2. Place accelerator pedal assembly over two mounting studs (1).
3. Install and tighten two mounting nuts (4). Refer to Torque Specifications.
