Commander 4WD V8-4.7L VIN N (2006)
13.
Highlight the listed calibration.
14.
Select "Update Controller". Follow on screen instructions.
15.
When the update is complete, select "OK".
16.
Verify the part number at the top of the "Flash SUNR" screen has updated to the new part number.
NOTE:
Due to the SUNR programming procedure, a DTC may be set in other modules within the vehicle, if so equipped. Some DTC's may cause the MIL to
illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press "Clear All Stored DTCs" if there are any DTCs shown on
the list.
17.
Insure the battery is at least 12 Volts.
18.
Place the ignition switch in RUN position.
19.
Close all of the doors and windows.
20.
Press and hold the vent switch until the sunroof glass moves to the full open vent position.
21.
Cycle the sunroof from the full vent open position to the full slide open position and back to the full vent open position at least 7 complete times.
The sunroof is now in customer mode with the obstacle detection thresholds updated.
22.
Remove the charger from the battery.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
