Commander 4WD V8-4.7L VIN N (2006)
Compressor Clutch Relay: Service and Repair
RELAY-A/C CLUTCH
NOTE:
-
LHD gasoline model shown. Diesel and RHD models similar.
-
Refer to the fuse and relay layout map on the inside of the PDC cover for A/C clutch relay location.
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Open the cover of the power distribution center (PDC) (1) located in the engine compartment.
3. Remove the A/C clutch relay (2) from the PDC.
INSTALLATION
1. Position the A/C clutch relay (2) into the receptacle of the power distribution center (PDC) (1).
2. Align the A/C clutch relay terminals with the terminal cavities in the PDC receptacle and push down firmly on the relay until the terminals are fully
seated.
3. Close the cover of the PDC.
4. Reconnect the negative battery cable.