Commander 4WD V8-4.7L VIN N (2006)
5.
Is vehicle a 2006 XK and was vehicle built prior to September 27, 2005?
a.
If YES >> then determine if Service Bulletin 08-054-05 has been performed. Complete SB 08-054-05 before proceeding with this bulletin.
b.
If NO >> then proceed to the next step.
6.
Using the StarSCAN(R), determine the current software level part number in the Front Control Module (FCM).
7.
Is the current FCM software level part number 04692024AJ (or later)?
a.
If YES >> then STOP. This bulletin does not apply and further diagnosis is required.
b.
If NO >> then perform the Repair Procedure.
SPECIAL TOOLS / EQUIPMENT REQUIRED:
REPAIR PROCEDURE - USING THE INTERNET TO RETRIEVE THE FLASH FILE:
NOTE:
The StarSCAN(R) diagnostic scan tool fully supports Internet connectivity. However, in order to take advantage of this feature you must first
configure the StarSCAN(R) for your dealership's network. For instruction on setting up your StarSCAN(R) for the dealer's network; refer to the
StarSCAN(R) Quick Start Networking Guide available on the website under the "download center".
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted.
1.
Install a battery charger and verify that the charging rate provides approximately 13.2 - 13.8 volts. Set the battery charger to continuous charge. Do
not allow the charger to time out during the flash process. Remove the charger from the battery when the flash process is complete.
2.
Connect the CH9410 StarSCAN(R) ethernet cable to the StarSCAN(R) and the dealer's network drop.
3.
Connect the CH9404 StarSCAN(R) vehicle cable to the StarSCAN(R) and the vehicle.
4.
Power ON the StarSCAN(R).
5.
Install a battery charger and verify that the charging rate provides approximately 13.2 - 13.8 volts. Set the battery charger to continuous charge. Do
not allow the charger to time out during the flash process. Remove the charger from the battery when the flash process is complete.
6.
Connect the CH9410 StarSCAN(R) ethernet cable to the StarSCAN(R) and the dealer's network drop.
7.
Connect the CH9404 StarSCAN(R) vehicle cable to the StarSCAN(R) and the vehicle.
8.
Power ON the StarSCAN(R).
9.
Select "ECU View"
10.
Touch the screen to highlight the FCM in the list of modules.
11.
Select "More Options"