Commander 4WD V8-4.7L VIN N (2006)
Engine Control Module: Service and Repair
Powertrain Control Module (PCM)
MODULE-POWERTRAIN CONTROL
CAUTION:
-
Certain ABS systems rely on having the Powertrain Control Module (PCM) broadcast the Vehicle Identification Number (VIN) over the bus
network. To prevent problems of DTCs and other items related to the VIN broadcast, it is recommend that you disconnect the ABS CAB
(controller) temporarily when replacing the PCM. Once the PCM is replaced, write the VIN to the PCM using a diagnostic scan tool. This is done
from the engine main menu. Arrow over to the second page to "1. Miscellaneous". Select "Check VIN" from the choices. Make sure it has the
correct VIN entered before continuing. When the VIN is complete, turn off the ignition key and reconnect the ABS module connector. This will
prevent the setting of DTCs and other items associated with the lack of a VIN detected when you turn the key ON after replacing the PCM.
-
Use a diagnostic scan tool to reprogram the new PCM with the vehicles original identification number (VIN) and the vehicles original mileage. If
this step is not done, a Diagnostic Trouble Code (DTC) may be set.
REMOVAL
The PCM (1) is attached to the right-front inner fender located in the engine compartment.
To avoid possible voltage spike damage to the PCM, ignition key must be off, and negative battery cable must be disconnected before unplugging PCM
connectors.
1. Disconnect and isolate negative battery cable.
