Commander 4WD V8-4.7L VIN N (2006)
5. Reinstall the hazard switch (2) onto the SCM (4).
6. Reinstall the left (lighting) multi-function switch (1) onto the SCM.
7. Reinstall the right (wiper ) multi-function switch (3) onto the SCM.
8. Reinstall the shrouds onto the steering column.
9. If a new SCM has been installed, remove the plastic locking pin that is securing the clockspring rotor to the SCM case to maintain clockspring
centering.
10. Reinstall the steering wheel onto the steering column.
11. Reconnect the steering wheel wire harness connectors to the upper clockspring rotor connector receptacles. Be certain that the steering wheel wire
harness is routed between the steering wheel back trim cover and the steering wheel armature.
12. Reinstall the driver airbag onto the steering wheel.
13. Reconnect the battery negative cable.
NOTE: Whenever the SCM is replaced with a new unit, it is necessary to configure the new module for certain optional equipment in the vehicle
using a diagnostic scan tool. Follow the programming steps outlined in the diagnostic scan tool for "Configure SCM" under "Miscellaneous
Functions" for the "SCM/Steering Control Module" menu item as appropriate.
