Commander 4WD V8-4.7L VIN N (2006)
Hood Sensor/Switch (For Alarm): Service and Repair
HOOD AJAR SWITCH
SWITCH
REMOVAL
1. Unlatch and open the hood.
2. Disconnect and isolate the battery negative cable.
3. From the top of the hood ajar switch mounting bracket (2) on the left inner fender shield, squeeze the two switch latch tabs together and pull the
switch (1) upward.
4. Pull the hood ajar switch up through the hole in the mounting bracket far enough to access and disconnect the wire harness connector (3) from the
switch connector receptacle.
5. Remove the hood ajar switch from the mounting bracket and discard.
INSTALLATION
NOTE: Self-adjustment of the hood ajar switch is a one-time feature. If the switch is damaged, ineffective, removed or requires readjustment, it must be
replaced with a new unit.
1. Position the hood ajar switch (1) near the hole in the mounting bracket (2) on the left inner fender side shield.
2. Pull the wire harness connector (3) through the switch mounting bracket and reconnect it to the switch connector receptacle.
3. From the top of the mounting bracket, press the switch downward into the mounting hole until the integral switch latch tabs lock it into place.
4. Reconnect the battery negative cable.
5. Close and latch the hood.
BRACKET