Commander 4WD V8-4.7L VIN N (2006)
4. Align the tabs on the brake lamp switch locking collar with the keyed hole in the brake pedal mounting bracket (2).
5. Insert the tab on the brake lamp switch locking collar through the keyed hole in the mounting bracket until the switch housing is firmly seated
against the bracket.
6. Rotate the switch housing clockwise about 30 degrees to engage the tabs on the locking collar with the mounting bracket.
CAUTION: Brake booster damage may occur if the brake pedal pull exceeds 20 pounds.
7. Release the brake pedal. Then pull the pedal lightly upward to its normal at-rest position. The pedal will set the plunger to the correct position as
the pedal pushes the plunger into the switch housing. The switch plunger will make a light audible ratcheting noise as it self-adjusts.
8. Reinstall the steering column opening cover onto the instrument panel.
9. Reconnect the battery negative cable.