Commander 4WD V8-4.7L VIN N (2006)
NOTE: Before tightening sensor nut, push downward on sensor housing (2) in an attempt to make it flush with interior contour of wheel (1).
4. While holding sensor in position, tighten sensor nut to 7.5 Nm (66 inch lbs.) torque.
CAUTION: Over-torquing the sensor nut by as little as 12 Nm (106 inch lbs.) may result in sensor separation from the valve stem. Under this
condition, the sensor may still function, however, the condition should be corrected immediately.
5. Mount tire on wheel following tire changer manufacturers instructions, paying special attention to the following to avoid damaging tire pressure
sensor:
a. Rotating Wheel Tire Changers - Once the wheel is mounted to the changer, position the sensor valve stem (2) approximately 2100 from the
head of the changer (located at 1) in a clockwise direction before rotating the wheel (also in a clockwise direction) to mount the tire. Use this
procedure on both the upper and lower tire beads.
