Commander 4WD V8-4.7L VIN N (2006)
1. Remove wheels.
2. Push back brake pads and release hand brake.
3. Remove propeller shaft.
4. Rotate pinion with inch pound torque and record torque to rotate.
5. Mark installation position of collared nut with respect to drive pinion.
6. Bend pinion nut lock back with a punch and hammer.
7. Hold pinion flange (1) with flange Wrench C-32812, and remove pinion nut.
8. Remove pinion flange (1) with Puller C-452 (2).
9. Remove pinion seal with a seal pick.
INSTALLATION
1. Install pinion seal with seal Installer C-3972A and Handle C-4171.
2. Install pinion flange (1) on pinion with flange Installer 9616 (2). Tap flange on pinion, then thread installer center bolt on pinion shaft and draw
